Movo SUTTON - Error Codes and Other Problems; Troubleshooting Error Codes; Common Issues and Solutions

BROME
User Guide
2. ERREUR CODE
3. OTHER PROBLEMS
TIRE : Low tire pressure: pump up tires to 30~35 psi.
Charger : During charging, light on charger doesn’t change to green.
22
Flash
Description
Initial check points
E02
Low Battery Fault
The batteries have run out of charge.
•
Recharge the batteries.
•
Check the battery and associated connections and wiring.
E03
High Battery Fault
Battery voltage is too high. This may occur if overcharged and/or traveling
down a long slope.
•
If traveling down a slope, reduce your speed to minimize the amount
of regenerative charging.
E04
Current limit time-out or
controller overheat
The motor has been exceeding its maximum current rating for too long.
•
The scooter may have stalled. Turn the controller off, leave for a few
minutes and turn back on again.
•
The motor may be faulty. Check the motor and associated
connections and wiring.
E05
Park Brake
Either a park brake release switch is active or the park brake is faulty.
•
Check the park brake and associated connections and wiring.
•
Ensure any associated switches are in their correct positions.
E06
Drive Inhibit
Either a stop function is active or charger inhibits or “out of neutral at
power up” condition has occurred.
•
Release the stop condition (seat raised etc.)
•
Disconnect the battery charger.
•
Ensure the throttle is in Neutral when turning the controller on.
•
The throttle may require re-calibration.
E07
Speed Pot
The throttle, speed limit pot. SRW or their associated wiring may be faulty.
•
Check the throttle and speed pot and associated connections and
wiring.
E08
Motor Voltage
The motor or its associated wiring is faulty.
•
Check the motor and associated connections and wiring.
E09
Other Error
The controller may have an internal fault.
•
Check all connections and wiring.