EDS-408A/405A Series User’s Manual Featured Functions
3-36
NOTE
If you enable the Hardware DIP Switch for Turbo Ring and set the Turbo Ring DIP Switch from
ON to OFF, then the Ring Ports and Coupler Ports that are added to all VLANs will be restored
to their previous software settings. (For details on how to do this, refer to “Configuring Basic
Settings—Turbo Ring DIP Switch.”)
Using this table, you can review the created VLAN groups and joined ports. (NOTE: The user
interface for EDS-408A shows 8 ports.)
Using Rate Limiting
A single device should not be allowed to occupy unlimited bandwidth, especially when the device
malfunctions. For example, broadcast storms could be caused by an incorrect topology or
malfunctioning device. The EDS-408A/405A series not only prevents broadcast storms, but can
also configure the ingress rate of unicast/multicast/broadcast packets, giving administrators full
control of the limited bandwidth, and preventing unpredictable faults before they occur.
Configuring Rate Limiting
NOTE: The user interface for EDS-408A shows 8 ports.
To Next Page
Loading...
Need help?
General
