MPMan TLX20HEA - BASIC OPERATION; SWITCHING THE LED TV ON;OFF; ADJUSTING THE VOLUME; SELECTING INPUT SOURCE

BASIC OPERATION
Press the VOL+/- button to increase or decrease the volume.
SELECTING INPUT SOURCE
1. Press the SOURCE button on the remote control or
press INPUT button on the rear panel of the LED TV
to display the “ Input ” menu.
2. Press the p/qbutton to select the input signal.
3. Press Enter button on the remote control or press
VOL+ button on the rear panel to confirm your
selection.
At any time, you can temporarily cut off the sound using the MUTE button.
1. Press the MUTE button and the sound cuts off.
2. Press the MUTE button again or press VOL+button to turn mute off.
USING MUTE
10
SWITCHING THE LED TV ON/OFF
ADJUSTING THE VOLUME
Input
DTV
ATV
AV
YPBPR
SCART
HDMI
PC
Media
To switch the LED TV on:
1. Connect the power cord to the LED TV, then the LED TV switches
power indicator on the front of the LED TV lights up in red.
2. To switch on the LED TV from standby:
Press the STANDBY button on the remote control or the POWER button on the front panel of the LED
TV, the LED TV switches on and the power indicator lights up in green.
To switch the LED TV off:
Press the STANDBY button on the remote control or the POWER button on the front of the unit again, the
LED TV switches to standby mode and the power indicator lights up in red.
itself to standby mode and the
CHOOSING A TV CHANNEL
Use the CH+/- button on the front panel, or the
Press the CH+ button to increase channel number.
Press the CH- button to decrease channel number.
Using 0-9 digital buttons
You can select the channel number directly by
Example:
To select 1-digit channel (e.g. Channel 5):
● Press the 5 button.
To select 2-digit channel (e.g. Channel 20):
● Press the 2 button, follow by 0.
To select 3-digit channel (e.g. Channel 100):
● Press the 1 button, follow by 0 and 0.
CH+/- button on the remote control.
pressing 0 to 9 buttons.
In TV mode, according to the type of signal being received, use the NICAM/EJECT button to select an
appropriate mode from the following: Mono, Stereo, Dual I and Dual II.
● When a mono program is received, you can only choose Mono.
● When a stereo program is received, you can switch between Stereo and Mono.
● When a bilingual program is received,you can switch among DualI, DualII and Mono.
DualI sends the primary broadcast language to loudspeakers.
DualII sends the secondary broadcast language to the loudspeakers.
SELECTING TV SOUND
36
-
+
volume