29
Appendix I: Parallel function
1. Introduction
This inverter can be used in parallel in only split phase equipment.
Maximum nine units work together to support split phase equipment. The supported maximum output
power is 54KW/54KVA.
NOTE: If this unit is bundled with share current cable and parallel cable, this inverter is default supported
parallel operation. You may skip section 3. If not, please purchase parallel kit and install this unit by following
instruction from professional technical personnel in local dealer.
2. Package Contents
In parallel kit, you will find the following items in the package:
Parallel board Parallel communication cable Current sharing cable
3. Parallel board installation
Step 1: Remove wire cover by unscrewing all screws.
Step 2: Remove two screws as below chart and remove 2-pin and 14-pin cables. Take out the board under the
communication board.
To Next Page
Loading...
Need help?
General