24
Step 3: Please select setting program by following the procedure.
This function is to upgrade inverter firmware. If firmware upgrade is needed, please check
with your dealer or installer for detail instructions.
:
Re-write
internal
parameters
This function is to over-write all parameter settings (TEXT file) with settings in the On-The-Go
USB disk from a previous setup or to duplicate inverter settings. Please check with your
dealer or installer for detail instructions.
Press “ ” button to export data log from the inverter to USB disk. If
the selected function is ready, LCD will display “ ”. Press “ ”
button to confirm the selection again.
Press “ ” button to select “Yes”, LED 1 will flash once every
second during the process. It will only display and all LEDs will
be on after this action is complete. Then, press “ ” button to
return to main screen.
Or press “ ” button to select “No” to return to main screen.
If no button is pressed for 1 minute, it will automatically return to main screen.
Error message for USB On-the-Go functions:
USB disk is protected from copy.
Document inside the USB disk with wrong format.
If any error occurs, error code will only show 5 seconds. After 5 seconds, it will automatically return to
display screen.
To Next Page
Loading...
Need help?
General