27
Error message for USB On-the-Go functions:
Error Code Messages
No USB disk is detected.
USB disk is protected from copy.
Document inside the USB disk with wrong format.
If any error occurs, error code will only show 3 seconds. After three seconds, it will automatically return
to display screen.
2. Timer Setting for Output Source Priority
This timer setting is to set up the output source priority per day.
Procedure LCD Screen
Step 1: Press and hold “ ” button for 3 seconds to enter Timer Setup Mode for output
source priority.
Step 2: Press “ ”, “ ” or “ ” button to enter the selectable programs (detail
descriptions in Step 3).
Step 3: Please select setting program by following each procedure.
Program# Operation Procedure
LCD Screen
Press “ ” button to set up Utility First Timer. Press “ ” button to select
starting time. Press “ ” or “ ” button to adjust values and press “ ” to
confirm. Press “ ” button to select end time. Press “ ” or “ ” button to
adjust values, press “ ” button to confirm. The setting values are from 00 to
23, with 1-hour increment.
Press “ ” button to set up Solar First Timer. Press “ ” button to select
starting time. Press “ ” or “ ” button to adjust values and press “ ” to
confirm. Press “ ” button to select end time. Press “ ” or “ ” button to
adjust values, press “ ” button to confirm. The setting values are from 00 to
23, with 1-hour increment.
Press “ ” button to set up SBU Priority Timer. Press “ ” button to select
starting time. Press “ ” or “ ” button to adjust values and press “ ” to
confirm. Press “ ” button to select end time. Press “ ” or “ ” button to
adjust values, press “ ” button to confirm. The setting values are from 00 to
23, with 1-hour increment.
Press “ ” button to exit the Setup Mode.
3. Timer Setting for the Charger Source Priority
This timer setting is to set up the charger source priority per day.
Procedure LCD Screen
Step 1: Press and hold “ ” button for 3 seconds to enter Timer Setup Mode for charging
source priority.
Step 2: Press “ ”, “ ” or “ ” button to enter the selectable programs (detail
descriptions in Step 3).
To Next Page
Loading...
Need help?
General