MRC BWLC-C2-K - Control of % Deviation Referring to the Inscribed Standard Mass; Standard Mass Determined by Its Weighing

Return to weighing:
•Press the key twice.
16.5.Control of % deviation referring to the inscribed standard mass
Scale software enables control of deviation (in %) of weighed loads
mass referring to the inscribed standard mass. Mass of standard can
be determined by its weighing (PrcA function) or entered to the scale
memory by an user (PrcB function).
16.5.1. Standard mass determined by its weighing
Procedure:
• Enter to <PrcA> function:
• You will see <LoAd> on the display and then:
• place an load on the pan which mass will be accepted as
standard
• press to confirm this operating mode
• after few seconds the indication 100,00% will be displayed
• From this moment display will not indicate mass of weighed load
- 45 -