• The completion of the calibration procedure is signalled
by the following message:
• Take off the weight from the pan, the message <donE> is
displayed for 1s and the program returns to the calibration submenu:
• Calibration process can be terminated anytime by pressing
which is signalled by the following message on the display:
• Return to weighing with saving changes that have been
made.
Caution:
If the calibration process (span adjustment) lasts longer than 15 the
<Err8> message will be displayed and short audible signal will be
emitted. Press to perform calibration again with more stable
ambient conditions!
17.3. Start mass adjustment
Option only for non-verified scales
Not accessible in BWLC…C2 scales of BWLC series
The scale can require only adjusting new start mass. In this scale adjusting
start mass can be excluded from the process of calibration and performed
separately.
- 64 -
To Next Page
Loading...