S-Cap-Air 13
6. Maintenance and Service
6.1. Intervals
This product should be regularly checked and serviced by specialists. Inspection
and service records must be maintained. Always use original MSA parts.
Repairs and maintenance must be carried out only by authorised service centres
or by MSA. Modifications to complete devices or components are not permitted
and automatically result in loss of approved status.
Intervals Maintenance and Service
after use § Filling the compressed air cylinder (à Section 4)
§ Cleaning and Disinfection (à Section 6.2)
§ Visual check (à Section 6.3).
unit was taken along, but
not used
§ Visual check (à Section 6.4), clean if necessary
when moving Check the units when moved to specific
locations/persons (à Section 6.4).
daily Units which are stored on site for immediate
emergency use (à Section 6.4).
monthly Regular checking of all units ready for service, even if
stored centrally (à Section 6.4)
annually Visual check, functional check (à Section 6.5)
6.2. Cleaning and Disinfection
Attention!
In order to prevent damage to the apparatus, it must not be immersed
in cleaning solutions or in water. Cleaning and disinfection must be
performed with a soft cloth.
Avoid drying in direct sunlight or radiated heat.
(1) Separate the hood and the tube from the valve.
(2) Thoroughly clean the hood and the inner mask with a Incides N cloth
(Manufacturer Ecolab GmbH) or disinfect with Incidin Rapid (Manufacturer
Ecolab GmbH).
(For concentration and residence time see instructions for Incidin Rapid)
(3) Allow all hood components to completely dry at 50°C max.
(4) Treat the lens on the inside and outside with a demisting agent (D2260700).
To Next Page
Loading...
