MSA S5000 - Electrical Connections and Mounting Options; Connecting Sensor to the Stack

Figure 12 Terminal Connections
4. Route the cable from the sensor through a conduit entry hole in the enclosure so that the sensor is oriented in the correct
position (see 3.6 Electrical Power Connections for details).
(Repeat to attach a second sensor to the S5000 transmitter).
5. Connect the sensor to the "Sensor 1" position on the electronics assembly.
a. If using a second sensor, connect it to the second sensor position.
NOTICE
If only using one sensor and it is connected to “Sensor2”position, the S5000 will enter Sensor Missing fault. See Disable
Sensor in 4.2.2 Sensor Setup for details on how to clear this fault.
Figure 13 Connecting Sensor to the Stack and
Grounding Terminal
Figure 14 SOURCE/SINK Switch Location
18
3 Installation US