To Next Page

To Previous Page

4.2.6 Calibration Alert

Sensors with TruCal technology actively monitor sensor and adjust sensitivity without any manual intervention. When

equipped with Diffusion Supervision, TruCal will also monitor the sensor inlet for obstructions while Diffusion Supervision is

enabled. These sensors do not need to be calibrated on a static maintenance cycle. When a manual calibration is

recommended, the sensor will detect this and slow flash either the left green LED or right green LED indicating that calibration

is recommended for sensor1 or sensor2 respectively. Users can also enable Calibration Alert so that an analog output signal

is sent to the control room when a calibration is recommended. Whether or not the calibration alert is enabled, if gas is detected

by the sensor, the S5000's analog output and display will follow the gas reading.

To Enable or Disable Calibration Alert:

1. Hold finger on button while menu selections scroll across screen.

2. Remove finger when Setup appears.

3. Touch button when Cal Alert is displayed.

The current Cal Alert setting is displayed (Enabled/Disabled).

4. Touch button to toggle desired status.

5. Touch button when "Finished?" is displayed to exit.

4.2.7 Bluetooth

Enable/Disable Bluetooth

If the device is ordered with Bluetooth, it will come enabled by default. If unit is not ordered with Bluetooth, it cannot be

retroactively added. This menu will not be displayed if the device was ordered without Bluetooth.

1. Hold finger on button while menu selections scroll across screen.

2. Remove finger when Setup menu appears.

3. Touch button when Bluetooth Setup is displayed.

The current Bluetooth setting is displayed (Enabled or Disabled).

4. To change the Bluetooth availability, touch button to change to the opposite state.

5. Touch button when "Finished?" is displayed to exit.

Bluetooth Pairing

The device memory has the ability to store up to 25 mobile devices in its memory. If a 26th device is paired, the memory will

erase the first device stored in its memory. Each time a device is paired, it is logged as an event that is viewable in the

X/SConnect App.

The S5000 blue LED in the middle left of the display will flash when a device is paired with it as a visual indication of the

pairing. Once paired with an S5000, the user will be able to connect to the same S5000 remotely and without a password,

unless over 25 other devices are paired with the same S5000 afterwards.

To pair with the S5000:

1. Download the X/S Connect App from the Google Play Store or the iOS App Store.

2. Open the X/S Connect App.

3. Select “Pair” for the S5000 that you would like to connect with.

4. (First Time Only) Enter Pairing Code on S5000 display.

4 Operation US

MSA S5000 User Manual

Questions and Answers: