2. Remove finger when Setup menu appears.
3. Touch button when Swap Delay is displayed.
The Swap Delay status is displayed (enabled or disabled).
4. To change the Swap Delay status, touch button to change to either enabled or disabled.
5. Touch button when "Finished?" is displayed to exit.
4.2.11 UI Password
Enable/Change Password
Enabling and changing the password is within the same menu. Enabling password will require the user to enter the password
before entering any of the settings menus. The password entry screen defaults to 0000 and is disabled by default.
If the password is lost, call GM Customer Service at +1-949-581-4464.
1. Hold finger on button while menu selections scroll across screen.
2. Remove finger when Setup menu appears.
3. Touch button when UI Password Setup is displayed.
The current UI Password setting is displayed (Enabled or Disabled).
4. Touch button to change to the opposite state.
5. Touch button when “Finished?” is displayed to save the enable/disable setting.
Next menu "New Password?" is displayed is for setting password. Default password is 0000 if enabled.
6. To change password, touch button when “No” appears on screen to change option to “Yes”.
7. Touch button while “Finished?” is displayed to save change.
8. The password entry screen will display a current password and each digit will blink for 4seconds starting from left.
9. While blinking, touch button to change desired numbers. The range is from 0to9 for each digit and 0000 to 9999 for all
4digits.
10. After changing the password, select “Finished?” to store the new password in the system.
Enter Password (if password is enabled)
If a password is enabled, the user must enter the password before entering any of the settings menus. The password entry
screen defaults to 000 and is disabled by default
1. Holding finger on button will display rotating left arrow then “password”.
2. Remove finger when UI Password appears.
3. The password entry screen will display with 0 and each digit will blink for 4seconds starting from left.
4. While blinking, touch button to change the desired numbers. The range is from 0to9 for one digit and 0000 to 9999 for all
4digits.
5. If the password is correct, holding finger on the button again will display rotating left arrow then go into the menu items.
As long as the setup menu is active, no password is required to enter again. If menu was not active for 30seconds,
the password will be required again.
57
US 4 Operation
To Next Page
Loading...
Need help?
General
