MSA SMC 5100-IT Series User Manual

Command 144: Set Transducer Serial Number
This command allows user to add a device specific serial number, if required. This is different from the serial number
assigned by the Manufacturer.
Request Data Bytes:
Byte Format Description
0-2 Unsigned-24 Serial Number
Response Data Bytes:
Byte Format Description
0 Unsigned-8 Response Code
1 Unsigned-8 Device Status
2-4 Unsigned-24 Returns new value of Serial Number
Command 145: Set Calibration Mode output current
Request Data Bytes:
Byte Format Description
0-1 Unsigned-16 Current output required during calibration, in micro-amperes
Command Specific Response Data Bytes:
Byte Format Description
0-1 Unsigned-16 Returns new Calibration current value
Command 146: Set Trouble Mode Output Current
Request Data Bytes:
Byte Format Description
0-1 Unsigned-16 Current output required to indicate Trouble, in micro-amperes
Command Specific Response Data Bytes:
Byte Format Description
0-1 Unsigned-16 Returns new Trouble current value
SMC 5100-XX-IT Toxic Gas Detector Module 59
US 13 HART

MSA SMC 5100-IT Series Specifications

General

Brand	MSA
Model	SMC 5100-IT Series
Category	Gas Detectors
Language	English