Installing VIA Chipset Driver
4-7
Note: Install Windows
®
NT4.0 Service Pack 6 or above before installing the
VIA drivers into Windows
®
NT.
Installing VIA® Chipset Driver
1. Insert the provided CD disk into the CD-ROM drive.
2. The CD will auto-run and the setup screen will appear.
3. Click on VIA Chipset Drivers and the screen will show VIA Service
Pack 4.XX.
4. Click Next and the screen will show the VIA Service Pack 1
README dialog box.
5. Click Ye s to proceed and then select Install to enable (Ultra) DMA
for IDE Driver.
6. The Choose Destination Location dialog box appears. Click Next.
7. The Select Program Folder dialog box appears. Click Next.
8. Click on Yes, I want to restart my computer and then click Finish to
restart your computer and complete installation.
Driver Installation for Windows
®
NT4.0
To Next Page
Loading...
