Chapter 3
3-12
HCLK The DRAM clock will be equal to the Host Clock.
HCLK+33 The DRAM clock will be equal to the Host Clock plus
33MHz. For example, if the Host Clock is 100MHz, the
DRAM clock will be 133MHz.
HCLK-33 The DRAM clock will be equal to the Host Clock minus
33MHz. For example, if the Host Clock is 133MHz, the
DRAM clock will be 100MH
When the installed CPU is 66MHz, this field has two setting options: HCLK
and HCLK+33. When the installed one is 133MHz, the two setting options
will become HCLK and HCLK-33. If you install one 100MHz CPU, then
three setting options are available: HCLK, HCLK+33 and HCLK-33.
DRAM Bank Interleave
This field enables or disables bank interleave feature for the installed
SDRAM. Disable the function if 16MB SDRAM is installed. Settings are
Disabled and Enabled. The default value is Enabled.
System Performance
This item enables you to enhance your system performance. But not every
DIMM installed on your system supports the function. Therefore, if your
system cannot run after selecting Turbo in the field, please set it back to
Normal. Settings are Normal and Turbo. Turbo provides better system
performance. The default value is Normal.
Memory Hole
In order to improve performance, certain space in memory can be reserved
for ISA cards. This memory must be mapped into the memory space below
16MB. When this area is reserved, it cannot be cached. The settings are
512KB-640KB, 15MB-16MB, 14MB-16MB and Disabled (default).
AGP Mode
The item sets an appropriate mode for the installed AGP card. Settngs are
1x, 2x, 4x and Auto (default). Select 4x if your AGP card supports the mode.
AGP Read Synchronization
The field allows you to enable or disable the AGP Read Synchronization
To Next Page
Loading...
