AMI
®
BIOS Setup
3-17
system, it singals this by causing an IRQ to occur. After receiving the
signal, when the operating system is ready, the system will interrupt itself
and perform the service required by the I/O device.
Power Button Function
This feature sets the function of the power button. Settings are:
On/Off The power button functions as normal on/off button.
Suspend When you press the power button, the computer
enters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer is
turned off.
Power Again
This item specifies whether you system will reboot after a power failure or
interrupt occurs. Available options are:
Power Off Leaves the computer in the power off state.
Power On Reboots the computer.
Last State Restores the system to the previous status before the
power failure or interrupt occurred.
Wake Up On Ring/LAN/PME#
When setting to Enabled, the features allow your system to be awakened
from the power saving modes through an incoming call from the modem, a
signal from the LAN, or any event on PME (Power Management Event).
Settings are Enabled and Disabled (default).
Note: You need to install a modem/LAN card supporting power on function
for Wake Up On Ring/LAN function.
Resume By Alarm
This is used to enable or disable the feature of booting up the system on a
scheduled time/date from the soft off (S5) state. Settings are Enabled and
Disabled.
Alarm Date/Hour/Minute/Second
If Resume By Alarm is set to Enabled, the system will automatically resume
(boot up) on a specific date/hour/minute/second specified in these fields.
To Next Page
Loading...
