Chapter 3
3-16
Sleep State LED
This item configures how the system uses sleep state LED on the case to
indicate the sleep state. Available options are:
Blinking The sleep state LED blinks to indicate the sleep state.
Single Color The sleep state LED remains the same color.
Dual Color The sleep state LED changes its color to indicate the
sleep state.
The default value is Dual Color.
Suspend Time Out (Minute)
The item specifies the length of the period of system inactivity before the
system enters the suspend mode from the standby mode. Nearly all power
use is reduced in the suspend mode. Settings are Disabled (default), 1, 2, 4,
8, 10, 20, 30, 40, 50 and 60 (Minutes).
Display Activity/IRQ3/IRQ4/IRQ5/IRQ7/IRQ9/IRQ10/IRQ11/IRQ13/
IRQ14/IRQ15
These items specify if the BIOS will monitor the activity of the specified
hardware peripheral or component. If set to Monitor, any activity detected
on the specified hardware peripheral or component will wake up the system
or prevent the system from entering the power saving modes. Settings are
Monitor and Ignore. The default values for different items are listed below:
Display Activity Ignore
IRQ3 Monitor
IRQ4 Monitor
IRQ5 Ignore
IRQ7 Monitor
IRQ9 Ignore
IRQ10 Ignore
IRQ11 Ignore
IRQ13 Ignore
IRQ14 Monitor
IRQ15 Ignore
Note: IRQ (Interrupt Request) lines are system resources allocated to
I/O devices. When an I/O device needs to gain attention of the operating
To Next Page
Loading...
