49
Upgrade MCU Firmware
Firmware of MEGA VIEW 588 can be upgraded. Firmware is more like BIOS
of mainboard, it might let the hardware device work better. You need a computer
and the supplied USB cable for the following procedures:
Note: To prevent battery runs out while upgrading and causes system failure,
it is recommended to plug the AC Adaptor to provide electricity.
Note: If you need to update both firmware and software, update firmware first.
1. Connect MEGA VIEW 588 to your computer with the USB cable.
2. Power on MEGA VIEW 588 to initialize it on your computer.
3. Download a MEGA VIEW 588 upgrade file from internet and save it into
MEGA VIEW 588 root directory. Double click to run the upgrade file, and
select “Replace all” on pop-up message to replace old files.
4. Safely remove MEGA VIEW 588 from your computer.
5. Select Setting from main menu and press down Navigation key to enter.
6. Push Navigation key left or right to select Info tab.
7. Push Navigation key up or down to select Update Firmware.
8. Push Navigation key to the right. Message "Update MCU Firmware? Yes
No" will appear on the display.
9. Push Navigation key right or left to select Yes and press down Navigation
key to start to upgrade firmware. Or select No and enter to cancel upgrade.
10. When firmware upgrade completes, system will restart.
To Next Page
Loading...
Need help?
General