50
Upgrade USB Firmware
Firmware of MEGA VIEW 588 USB chip can be upgraded to support latest
USB products. You need a computer and the supplied USB cable for the
following procedures:
Note: To prevent battery runs out while upgrading and causes system failure,
it is recommended to plug the AC Adaptor to provide electricity.
Note: Update USB Firmware is for supporting more USB devices.
1. Power on MEGA VIEW 588.
2. Select Setting from main menu and press down Navigation key to enter.
3. Push Navigation key left or right to select Info tab.
4. Push Navigation key up or down to select Update USB Firmware.
5. Push Navigation key to the right, below message will appear on the display
to tell you to connect MEGA VIEW 588 to your computer.
6. Connect MEGA VIEW 588 to your computer with the USB cable, then you
will see the message below to remind you not to disconnect the USB cable,
or the system might be failure.
7. Download USB firmware upgrade file of MEGA VIEW 588 from internet,
unzip the file into a folder and remember the location.
To Next Page
Loading...
Need help?
General