CHAPTER 3 AWARD BIOS SETUP
Boot Sequence
This category determines which drive the computer searches first for
the disk operating system (i.e., DOS). The settings are A,C,SCSI/C,A,SCSI/
C,CD-ROM,A/CD-ROM,C,A/D,A,SCSI/E,A,SCSI/F,A,SCSI/SCSI,A,C/
SCSI,C,A/C only. Default value is A,C,SCSI.
Swap Floppy Drive
Switches the floppy disk drives between being designated as A and
B. Default is Disabled.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed is
40 or 80 tracks. 360K type is 40 tracks while 720K, 1.2M and 1.44M are all 80
tracks.
Enabled(default) BIOS searches for floppy disk drive to deter
mine if it is 40 or 80 tracks. Note that BIOS can
not tell from 720K, 1.2M or 1.44M drive type as
they are all 80 tracks.
Disabled BIOS will not search for the type of floppy disk
drive by track number. Note that there will not
be any warning message if the drive installed is
360K.
Boot Up NumLock Status
The default value is On.
On (default) Keypad is number keys
Off Keypad is arrow keys
3-11
To Next Page
Loading...
