MSI MS-5148 - Gate A20 Option; Typematic Rate Setting

CHAPTER 3 AWARD BIOS SETUP
Boot Up System Speed
It selects the default system speed - the speed that the system will
run at immediately after power up.
High (default) Set the speed to high
Low Set the speed to low
Gate A20 Option
Normal The A20 signal is controlled by keyboard
controller or chipset hardware.
Fast(default) Default : Fast. The A20 signal is controlled by
Port 92 or chipset specific method.
Typematic Rate Setting
This determines the typematic rate.
Enabled Enable typematic rate and typematic delay
programming
Disabled(default) Disable typematic rate and typematic delay
programming. The system BIOS will use default
value of this 2 items and the default is control
led by keyboard.
Typematic Rate (Chars/Sec)
6 (default) 6 characters per second
8 8 characters per second
10 10 characters per second
12 12 characters per second
15 15 characters per second
20 20 characters per second
24 24 characters per second
30 30 characters per second
3-12