CHAPTER 3 AWARD BIOS SETUP
Resume by Alarm
This function is for setting date and time for your computer to boot
up. During Disabled you can not use this function. And during Enabled
choose the Date and Time Alarm:
Date(of month) Alarm You can choose which month the system
will boot up.
Time(hh:mm:ss) Alarm You can choose what hour, minute and
second the system will boot up.
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system, before this function will work.
IRQ 8 Clock Event
IRQ[3-7,9-15], NMI : Enabled
Primary IDE 0 : Enabled
Primary IDE 1 : Disabled
Secondary IDE 0 : Disabled
Secondary IDE 1 : Disabled
Floopy Disk : Enabled
Serial Port : Enabled
Parallel Port : Enabled
During Enabled, if any interrupt event happened the system will turn
on form the suspend mode. And during Disabled, the system will not
monitor any interrupt event.
3-25
To Next Page
Loading...
