MS-7520 Mainboard
2-20
Serial ATA Connector: SATA1~10
This connector is a high-speed Serial ATA interface port. Each connector can connect
to one Serial ATA device.
SATA7 & 8 are controlled
by 1st JMB322
SATA1~6 stack SATA connectors
are supported by ICH10R
SATA7
SATA1_3
SATA2_4
Important
1. Please do not fold the Serial ATA cable into 90-degree angle. Otherwise,
data loss may occur during transmission.
2. Please always use the Intel default Black SATA connectors (SATA1~6)
first.
3. SATA7 & SATA8, SATA9 & SATA10, support RAID 0/ RAID 1/ JBOD function
and you can set RAID mode in BIOS setup or in DRIVE BOOSTER MAN-
AGER (refer to the BIOS section or Appendix section).
SATA5_6
SATA9
SATA8
SATA10
SATA9 & 10 are controlled
by 2nd JMB322
To Next Page
Loading...
