10
REF. NO. PARTS DESCRIPTION QTY. PART NO.
Spa cover with aluminum foil inside
Spa tub
Control panel with air pipe
Heat preservation bubble mat
Digital lock
Inflation hose
Manometer
Filter cartridge set (twin pack)
Spa cover inflatable bladder
Spa drain valve adaptor
Wrench
Instruction DVD
Repair kit
B9300868
B9300109N
B9300672
B9300671
B9300637
B0301964
B0301969
B9300670
B9300419
/
B9301006
NOTE: When ordering parts, be sure to quote the model number and part numbers.
FIRST USE AND SET-UP PREPARATION
The spa can be installed indoor and outdoor. For household use only.
The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the
maximum load of the filled spa with listed maximum occupants.
Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can
damage the spa and void your warranty. Level the surface before filling spa with water.
Provide adequate drainage system around the spa to deal with overflow water and splashes.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
Site preparation and requirements
Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check
with a qualified contractor or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of
any other material that could damaged by the moisture.
Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
Additional requirements for indoor installation
1
1
1
1
1
1
1
1
1
1
1
1
1
B9300884
A
B
C
D
E
F
G
H
I
J
K
L
M
To Next Page
Loading...
Need help?
General
