How to fix no display on mspa OSLO control panel?
If the control panel of your MSpa Hot Tub shows no display, first, try changing the power socket or repairing the existing one, as the issue might be a power socket failure. If that doesn't work, reset the PRCD by following the PRCD Testing section, because the PRCD might be off.
How to fix jet function failure (with icon) in mspa OSLO?
If your MSpa hot tub has a jet function failure (with icon), it might be due to low water or ambient temperature. Heat the water up to 20°C (68°F). Also, the protection system might be too sensitive; ensure the water temperature is above 20°C (68°F), then long-press the JET button for 3 seconds to unlock the JET function. If this doesn’t work, continue heating the water and try again later.
What causes the filter pump to not work in mspa OSLO?
If the filter pump of your MSpa Hot Tub does not work, the filter cartridge might be clogged by dirt or other objects. Clean or replace the filter cartridge to resolve this.
Outlines severe risks like drowning, injury from damaged cords, and electric shock hazards.
Details electrical safety, GFCI testing, grounding requirements, and avoiding extension cords.
Covers warnings on rain usage, child supervision, cord placement, pets, and health advisories.
Explains grounding terminals, bonding lugs, and required conductor sizes for electrical safety.
Includes warnings on adult supervision, suction guards, infectious diseases, and chemical use.
Warns about alcohol, drugs, and hyperthermia risks, including symptoms and effects.
Provides cautions on spa use, alone use, after exercise, and consulting a physician.
Identifies buttons, indicators, temperature display, and energy saving mode.
Covers turning the heater on/off, setting temperature, and anti-icing system.
Lists error codes, their causes, and recommended solutions.
Addresses issues like no display, leaks, heating problems, water clarity, and pump failures.
To Next Page
General
