EasyManuals Logo

MST Impact NS5001 User Guide

MST Impact NS5001
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
IllustrationProcedureStep
Remove the dust cap from the
antenna port.
1
Connect the coaxial cable plug to
the RP-TNC jack on the NS50 and
tighten the outer sleeve.
2
Insulate the connection using
self-amalgamating rubber tape.
Start at the base of the connection
and pull back the rubber tape
backing.
3
Pull the tape tightly, and tape
around the connector at an angle
until it is 25mm past the end of the
connection.
4
NS50 User Guide39Revision C
Installation

Table of Contents

Other manuals for MST Impact NS5001

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MST Impact NS5001 and is the answer not in the manual?

MST Impact NS5001 Specifications

General IconGeneral
BrandMST
ModelImpact NS5001
CategorySwitch
LanguageEnglish

Related product manuals