MST Impact NS5001 User Guide

5.4.3 Rebooting or Restoring the Network Device
The System conguration screen enables the device to be rebooted or restored to the factory default
settings.
Click Reboot the Device to reboot the device. Any unsaved settings on the device will be lost and the
connection will terminate.
Click Restore all Settings to the Factory Defaults to restore the device to default settings. All current
settings will be erased.
5.4.4 Upgrading Firmware
Device Firmware can be upgraded from the Firmware upgrade screen as shown below. The rmware is
a binary (.bin) le format.
Note:
• WAC 1 must be upgraded before WAC 2. Complete steps 1-4 for for every WAC on the network
that you are upgrading, then move onto step 5.
• Firmware upgrades may reset the network device to default factory settings (please refer to the
rmware release notes to determine if this will occur).
• It is STRONGLY recommended to install ICA 1.4.1 (or greater) at the site and use the central
conguration management capability to re-apply device settings. See Device Management
Overview on page 86 for more detailed instructions.
• For devices that are not managed by the ICA, conguration settings can be saved before updating
rmware and restored after the update from the TOOLS > ADMIN screen. For more
information, see Saving and Restoring Conguration Settings on page 60.
NS50 User Guide63Revision C
Conguration Using the Web Interface

MST Impact NS5001 Specifications

General

Brand	MST
Model	Impact NS5001
Category	Switch
Language	English