MST Impact NS5001 User Guide

The Switch ports have the following conguration options:
Recommended SettingsDescriptionField
Naming is specic to each device.Used to provide a convenient name for the port.
It is often used to name the device connected to
it. For example, "Level 68 camera".
Name
On or Off.Enables or disables the port.Enabled
Auto is usually the best setting.
However some devices require
Ports 5 thru 8 allow the speed and duplex to be
controlled.
Speed & Duplex
Speed & Duplex to be hard coded
due to poor Auto-negotiation
implementations.
Enabling 48v Power Over Ethernet
48VDC PoE supply for ports 5-8 can be enabled by selecting the PoE Power Rail Enable check box. If
this setting has been changed but not saved, the Reset PoE button will change it back to its saved setting.
If the voltage to the NS50 is too low to enable PoE on startup, the following message will be displayed:
NS50 User Guide79Revision C
Conguration Using the Web Interface

MST Impact NS5001 Specifications

General

Brand	MST
Model	Impact NS5001
Category	Switch
Language	English