MST Impact NS5001 User Guide

SolutionPossible CausesProblem
Disable security on WDS link using the web interface.Security settings do not match on each
side of the WDS link.
Check the connectors and bre ports are clean. Clean
using alcohol wipes or bre optic cleaning kits. NB: Do
Composite connector or bre port is
dirty.
Signal loss in the
bre optic cable.
not use air spray as the compressor oil can leave residue.
Refer to Composite Cable Testing on page 95 for testing.
There is a conguration problem with
the PC.
The Internet or
the LAN cannot
be accessed with
• Re-boot the computer with the wireless adapter that
has had TCP/IP changes applied to it. The computer
with the wireless adapter may not have the correct
TCP/IP settings to communicate with the network.
a wireless-capable
PC.
• Restart the computer and check the network settings.
Refer to Connecting a PC to an ImPact Network
Device on page 105. If this is not resolved, try changing
the DHCP setting to Obtain an IP address
automatically.
• Check the NS50 default conguration against the
conguration of other devices on the network.
Check the port activity light is on. If the light is not on,
connect a PC to the network switch to access the web
The port on the NS50 is disabled.
browser interface. Go to the Basic > Switch screen and
check the port is enabled.
Connect a PC to another port on the network switch to
access the network. In the web browser interface, check
VLAN(s) on the port are not properly
congured.
that VLAN membership is assigned to the port for Internet
/ LAN access.
Revision C94NS50 User Guide
Troubleshooting Guide

MST Impact NS5001 Specifications

General

Brand	MST
Model	Impact NS5001
Category	Switch
Language	English