MTD 315-800-000 - Starting Instructions

I
FIGURE 19. FIGURE 20.
Throttle Control (See figures 18 and 20)
The throttle control is located on the righ hand
side of the handle panel. It regulates the speed of
the engine.
Drive Clutch (See figure 18)
The drive clutch is located on the left handle.
Squeeze the clutch grip to engage drive. Release
to stop.
Auger Clutch (See figure 18)
The auger clutch is located on the right handle.
Squeeze the clutch grip to engage the cugers.
Release to stop the snow throwing action.
Chute Crank (See figure 18)
The chute crank is located on left hand side of the
snow thrower.
To change the direction in which snow is th rown,
turn chute crank as follows:
1. Crank clockwise to discharge to the left.
2. Crank counterclockwise to discharge o the
right.
Safety Ignition Switch (See figure 21)
The ignition key must be inserted in the s witch
before the unit will start. Remove the ignition key
when snow thrower is not in use.
FIGURE 21.
STARTING INSTRUCTIONS
1. Remove dipstick. Fill crankcase with oil. Oil
level must be to full mark on dipstick. Refer to
separate engine manual packed with your
snow thrower.
2. Fill fuel tank with fresh, clean regular
gasoline.
AC WARNING J
Never fill fuel tank indoors, with en¬
gine running or while engine is hot.
3. Attach spark plug wire to spark plug.
4. Insert ignition key (do not turn).
5. Place shift lever in “NEUTRAL” (N) position.
6. Place throttle control in “START” (fast) posi¬
tion.
AC WARNING J
Never run engine indoors or in en¬
closed poorly vented area. Engine
exhaust gases contain carbon mon¬
oxide: an odorless and deadly gas.
7. Start engine, following appropriate instruc¬
tions:
A. Cold engine start (engine has not been run
recently).
1. Turn choke knob to “full" position. See
figure 21.
2. Push primer two (2) or three (3) times.
See figure 21.
10