MTD 315-800-000 - Page 4

I
This owner’s manual covers various
models of snow throwers. The uni
illustrated may be different thar
your unit.
NOTE
This unit is shipped WITHOUT GAS
OLINE or OIL. After assembly, see
separate engine manual for propei
fuel and engine oil recommenda
tions.
^ A
FIGURE 2.
ASSEMBLY
Reference to right hand or left hand
side of machine is observed from
the operating position.
Tools Required for Assembly:
9/16" Wrench
1/2" Wrench
7/16" Wrench
or One Adjustable Wrench
Loose Parts in Carton:
(1) Handle Assembly
(1) Chute Assembly
(1) Parts taped together which include:
(1) Drive Clutch Rod Assembly
(1) Auger Rod
-*-(1) Shift Rod
(1) Chute Crank Assembly
Contents of Hardware Pack:
A (2) Hex Bolts 3/8-16 x 2" Long
B (3) Belleville Washers 3/8" I.D.
C (2) Hex Nuts 5/16-18 Thread
D (1) Belleville Washer 5/16" I.D.
E (3) Chute Flange Keepers
F (6) Hex Lock Nuts V4-20 Thread
G (1) Flat Washer 3/8" I.D. x 5/8" O.D.
H (1) Large Flat Washer
I (1) Hex Bushing
J (1) Cotter Pin
K (1) Hairpin Cotter
L (1) Compression Spring
——M (1) Elastic Lock Nut 3/8-24 Thread
N (2) Ignition Keys
O (2) Hex Bolts 5/16-18 x 1%" Long*
P (2) Hex Lock Nuts 5/16-18 Thread*
Q (1) Shift Lever
*The augers are secured to the spiral shaft with
two hex bolts and hex lock nuts (see ref. nos. 40
and 50 on page 24). If you hit a foreign object or
ice jam, the snow thrower is designed so that the
hex bolts will shear. Two replacement hex bolts
and nuts are provided in the hardware pack for
your convenience. Store in a safe place until
needed.
1. Remove snow thrower and all parts from the
carton. Make certain that all loose parts and
literature have been removed before the car¬
ton is discarded.
2. Extend throttle control assembly which is at¬
tached to engine at rear of the snow thrower
and place on floor. Be careful not to bend or
kink control wire.
-*-3. To assemble the handle, loosen one self¬
tapping screw and belleville washer on each
side of the unit. See figure 3. A 9/16" wrench
or adjustable wrench is required.
4