MAINTENANCE AND STORAGE
1. Never tamper with safety devices. Check
their proper operation regularly.
2. Disengage all clutch levers and stop en
-
gine. Wait until the auger/impeller come to
a complete stop. Disconnect the spark
plug wire and ground against the engine to
prevent unintended starting before clean
-
ing, repairing, or inspecting.
3. Check bolts, and screws for proper tight
-
ness at frequent intervals to keep the
machine in safe working condition. Also, vi
-
sually inspect machine for any damage.
4. Do not change the engine governor setting
or over-speed the engine. The governor
controls the maximum safe operating
speed of the engine.
5. Snow thrower shave plates and skid shoes
are subject to wear and damage. For your
safety protection, frequently check all com
-
ponents and replace with original
equipment manufacturer’s (O.E.M.) parts
only. “Use of parts which do not meet the
original equipment specifications may lead
to improper performance and compromise
safety!”
6. Check clutch controls periodically to verify
they engage and disengage properly and
adjust, if necessary. Refer to the adjust
-
ment section in this operator’s manual for
instructions.
7. Maintain or replace safety and instruction
labels, as necessary.
8. Observe proper disposal laws and regula
-
tions for gas, oil, etc. to protect the
environment.
9. Prior to storing, run machine a few minutes
to clear snow from machine and prevent
freeze up of auger/impeller.
10. Never store the machine or fuel container
inside where there is an open flame, spark
or pilot light such as a water heater, fur
-
nace, clothes dryer etc.
11. Always refer to the operator’s manual for
proper instructions on off-season storage.
4
To Next Page
Loading...
Need help?
General
