EasyManua.ls Logo

MTD 350 - User Manual

MTD 350
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Front Tine Tillers
Model Series
340 Thru 390
Operator’s Manual
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.
PRINTED IN U.S.A.
FORM NO.
770-10135C.fm
(11/03)
Model Series 390 Shown

Table of Contents

Questions and Answers

  • A
    alexandermcdowellAug 11, 2025
    Why MTD Tiller engine fails to start?
    • M
      Michele SmithAug 11, 2025
      The engine might fail to start due to several reasons: the fuel tank is empty or the fuel is stale, the throttle control lever is not in the correct starting position, the fuel line is blocked, the air cleaner is dirty, the choke is not in the ON position, the spark plug wire is disconnected or the spark plug is faulty. To solve this: * Fill the tank with clean, fresh gasoline, and remember that fuel will not last over thirty days unless a fuel stabilizer is used. * Move the throttle lever to the start position. * Clean the fuel line. * Move the switch to the ON position. * Connect the wire to the spark plug. * Clean, adjust the gap, or replace the spark plug.
  • R
    Ronald FreemanAug 21, 2025
    What to do if MTD Tiller engine runs erratic?
    • S
      Stephanie JohnsonAug 21, 2025
      If the engine runs erratically, it could be due to: * The unit running on CHOKE. * A loose spark plug wire. * A blocked fuel line or stale fuel. * A plugged vent in the gas cap. * Water or dirt in the fuel system. To fix this, move the choke lever to the OFF position, connect and tighten the spark plug wire, clean the fuel line, fill the tank with clean, fresh gasoline (fuel won't last over thirty days without a fuel stabilizer), clear the vent in the gas cap, or drain the fuel tank and refill with fresh fuel.
  • H
    Heather AllenSep 1, 2025
    How to fix MTD Tiller when tines do not engage?
    • T
      taylorjohnsonSep 1, 2025
      If the tines do not engage, it could be due to a foreign object lodged in the tines, missing tine clevis pins, the pulley and idler not in the correct adjustment, the control cable not adjusted properly, or a worn and/or stretched belt. To resolve this, dislodge any foreign object, replace any missing tine clevis pins, or replace the belt.

MTD 350 Specifications

General IconGeneral
TypeTwo-Stage
Auger MaterialSteel
Engine Type4-Cycle
Starter TypeElectric
Chute ControlManual
Skid ShoesAdjustable
Clearing Width21 inches

Related product manuals