Quickset Speed
Press the thumbwheel, enter a
desired speed on the keypad, then
press the thumbwheel again. Your
engine will smoothly accelerate or
decelerate to that speed setting.
Observe speed restrictions on your
railroad like a real engineer!
1. Press MENU
2. Select SYSTEM
3. Select REMOTE SETUP
4. Select QUICKSET SPEEED
5. Select ON or OFF
6. When ON is selected you are able
to send any speed you want to an
engine quickly
7. Press the ENG button and then
select a DCS-equipped engine from
the list
8.Press down on the thumbwheel
(Select) and you will see the display
change to indicate “QUICKSET
SPEED”
9.Using the numeric keypad enter the
speed you want that engine to go
10. Press the thumbwheel down
again (Select) and you will see your
engine moving at the speed you
selected
8
To Next Page
Loading...
