32
Setup Real Time Clock
DoloBravo has a “Real Time Clock”, that shows year, month, day, hours and minutes to allow
the therapeutic memory the temporal assignment of detailed treatment data.
For setting time and date, please select any custom program 13-15 and press the SET-button
for at least 5 seconds. You’ll reach the conguration-mode. Now press SET once again for 10
seconds.
With the +/- button of channel A (left side) you can step forward to the following values
- hour (indicated by: H)
- minute (indicated by: MI)
- day (indicated by: dA)
- month (indicated by: MO)
- year (indicated by: Y)
The respective value is ashing and can be changed with the +/- buttons of channel B (right
side). Finally you save all your settings by pressing the PRG-button once again.
Before starting the therapy, please set the clock once if necessary.
If DoloBravo has been without batteries for more than 30 minutes, the clock must be set again.
Safety Adjustments
1. The +buttons become inactive after one minute running time of a program to avoid an un-
intentional increase of intensity . This lock is switched off again, only by pressing the +button
three-times repeatedly. Now an increasing of intensity is possible again for another minute.
2. If the electrical circuit should be interrupted during operation (> 6 mA), for example by
losing an electrode or by a broken lead wire, the device stops stimulating immediately.
3. If any phase comes to its end, the intensity falls down to 8 mA automatically and must be
reset by the user to the desired setting.
To Next Page
Loading...
