MTR DoloBravo - Setting the Custom Programs

DoloBravo Bedienungsanleitung / Operators Manual
38
Setting the
Custom Programs 13-15
1. Switch on DoloBravo with „ON/OFF” button.
2. Choose the desired program (13-15) with „PRG” button.
3. Press „SET” button for at least ve seconds. DoloBravo changes to the programming mode
and the upper watch, which indicates phase duration, ashes to show that this function can be
altered.
In the following please use the left „+” button always then, if you want to store your
choice and to change to the next step. The right „+/-” buttons are respectively used in
order to alter the chosen and ashing parameter.
4. Select with the right „+/-”buttons the desired time for the rst phase.
5. By pressing the left „+”button you will be able to store your choice and change to the next
step. In the display the mode now ashes, which you adjust according to your wishes by
pushing the right „+/-”buttons.
If you have chosen „CONT” or „BURST” you can determine frequency and after storage and
change with the left +button respectively the pulse width by pushing the right „+/-” buttons.
If you have chosen „WORK/REST”- rhythm you can determine the following parameters one
after the other by pushing the right „+/-”buttons.
- frequency (Hz)
- pulse width (µS)
- work time (sec)
- rest time (sec = recovery time)
- increase / decrease ramp up time of the pulse (RU)
- increase / decrease ramp down time of the pulse (Rd)
- synchronous (SY) or alternating (AL) output of the channels A and B. If you have selected
“SY” you can program delay-time (dL) of 0 sec. up to 5 sec. from channel A to B.
If you have chosen „MOD” you can alter the following parameters one after the other.
- low limit of frequency (Hz LO)
- upper limit of frequency (Hz HI)
- low limit of pulse width ( µS LO)
- upper limit of pulse width (µS HI)
- low limit of intensity (AdJ) - the display in the right corner below shows values from 0.5 to
1.0. This adjusts the intensity of current within the modulation time between 50% (=0.5) and
100% (=1.0) of the original set mA-value. The intensity, of a modulated program, can never
increase above the 100% of the set value.
- modulation time (possible choice: 2 sec. up to 60 sec)