39
6. Push the „SET”button to select the second phase of the program. You can program up to
5 phases of your own in each of the three congurable programs. If you want to reduce a
congured program of 5 phases to less phases, you simply set the time of the rst unwanted
phase to zero.
7. The programming is completed by pressing the „PRG” button and the program is stored.
Selectable frequency and pulse width settings:
Continuous-Mode: 1 to 200 Hz, 50 to 450 µS
Burst-Mode: 35 to 200 Hz, 50 to 200 µS
Modulated-Mode: 1 to 200 Hz, 50 to 450 µS
Work/Rest-Mode: 1 to 200 Hz, 50 to 450 µS
It is not possible to program more than 300 µS if the frequency is above 100 Hz.
The settings can be made as follows.
• Frequency: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 12, 14, 15 Hz, and then increasing in 5 Hz steps until
max. 200 Hz
• Pulse width; 50 to 450 µS in steps of 10 microseconds
• Intensity: 50-100% in steps of 10%
• Modulation time: 2, 3, 4, 5, 6, 7, 8, 9, 10, 12, 15, 20, 30, 40, 50, 60 seconds
• Work time: 2-99 seconds in steps of 1 second
• Ramp up time: 0,1-9,9 seconds in steps of 1 second
• Ramp down time: 0,1-9,9 seconds in steps of 1 second
• Rest time: 2-99 seconds in steps of 1 second
• Delay: 0,0-5,0 seconds in steps of 0,1 second
• Session time: 1-599 minutes in steps of 1 minute
Setting the
Custom Programs 13-15
To Next Page
Loading...
