42
Abbreviations
AdJ: Adjustment of intensity
AL: Alternate function of the channels A and B
BURST: The burst mode delivers 2 blocks of 9 impulses each per second
CONT: In the continuous mode a permanent unchanged current is used
dA: Day
dEL Delete
dL: Delay between channels A and B
HAN: Change of frequency and pulse width in a 3:3 seconds rhythm (indicated as
CONT + BURST)
HI: Upper value (high)
Hz: Hertz is the measurement unit for the frequency of impulses per second.
LO: Lower value
mA: Milli-amp is the measurement unit for the electrical current intensity.
MOD: In the modulated mode the frequency and/or the pulse width and/or the intensity
changes in a predened rhythm automatically.
Rd: Ramp down
RU: Ramp up
SEC: Seconds
SY: Synchronous function of the channels A and B
TI: Time
TM: Time of modulation-interval
W/R: Work/Rest mode
µS: Microsecond is the measurement unit for the length of every single impulse.
To Next Page
Loading...
