mtts Dolphin CPAP - Device Description - User Interfaces; CPAP Display and Controls

V.1.04.EN
Dolphin CPAP. User manual
LPM
2
O
Fi
°C
2
O
Fi
cm H O > 14
2
O
2
AIR
LPM
T2
T1
T1
T2
LPM
2
O
Fi
°C
2
O
Fi
cm H O > 14
2
O
2
AIR
LPM
T2
T1
T1
T2
10
Device Description
Device Description
11
CPAP Display
1
2
1 On / Off Button
Hold this button for 2 seconds to turn the CPAP
display and functions on and off.
2 Set Flow Rate Display 
3
Set Flow Rate
Adjustment Arrows
Use these buttons to increase or decrease the

4 Set FiO
2
Display Shows the selected FiO
2
as a percentage.
5
Set FiO
2
Adjustment Arrows
Use these buttons to increase or decrease the
FiO
2
percentage.
3
4
5
6
8 7
10
6 Alarm Silence Button
Press this button to temporarily silence CPAP
alarm sounds for 110 seconds. Press it again to
restore alarm sounds.
7
Set Temperature
Button
Set temperature button: See Operation (CPAP),
step 4.
-
ture set point
8 Measured FiO
2
Display Shows the FiO
2
of the gas delivered to the patient.
9
Measured
Temperature Display
Shows the lower of the measured temperatures
      

ready for use.
10 CPAP Alarm System
See the
Alarm System (CPAP) section for detailed
information about the CPAP alarm system.
Accessories
Part Order Code Component of
 CPD-10800 Breathing Circuit
PEEP Chamber CPD-10900 Breathing Circuit
Silicon Tube Set CPD-11001 Breathing Circuit
Heater Wire Draw Line CPD-11002 Breathing Circuit
Temperature sensor CPD-11003 Breathing Circuit
Heater Wire Connector CPD-11004 Breathing Circuit
Oxygen Sensor CPD-11100 Control box
Inlet Gas Filter CPD-11200 Control box
Cleaning Brush CPD-11300 Reprocessing
Pulse ox Sensor CPD-11400 Pulse ox
Dolphin CPAP set is provided with following accessories (one piece of each):
9