3. Remove cut-out oil filter using the oil filter
wrench.
4. Clean the sealing face on the adapter.
5. Check condition of the new sealing ring and
coat it with oil.
6. Fit SOLAS shield (→ Page 19).
7. Screw on and tighten new engine oil filter
by hand.
8. Replace other oil filters in the same way.
9. Switch filter to normal position.
10. After each oil change and filter replace‐
ment, bar engine with starting system
(→ Page 77).
11. Check oil level (→ Page 118).
Oil filter replacement with the engine running
1. Reduce engine speed to <1100 rpm.
2. Remove cut-out oil filter using the oil filter wrench.
3. Clean the sealing face on the adapter.
4. Check condition of the new sealing ring and coat it with oil.
5. Fit SOLAS shield (→ Page 19).
6. Screw on and tighten new engine oil filter by hand.
7. Replace other oil filters in the same way.
8. Switch filter to normal position.
9. Check oil level (→ Page 118).
122 | Task Description | MW15407/14E 2012-02
TIM-ID: 0000036392 - 001
To Next Page
Loading...
