MTU 8 V 2000 M70 - Table of Contents

Table of Contents
1 Safety
1.1 General conditions 5
1.2 Personnel and organizational requirements 6
1.3 Transport 7
1.4 Crankshaft transport locking device 8
1.5 Safety regulations for startup and operation 11
1.6 Explosion hazard when removing
inspection port cover on engine 12
1.7 Safety regulations for maintenance and
repair work 13
1.8 Auxiliary materials, fire prevention and
environmental protection 16
1.9 Conventions for safety instructions in the
text 18
2 General Information
2.1 Product description 19
2.2 2000 M70 engines 28
2.3 Engine side and cylinder designations 29
3 Technical Data
3.1 8V 2000 M70 engine data: Engine-
mounted heat exchanger 30
3.2 8V 2000 M70 engine data: Separate heat
exchanger 33
3.3 12V 2000 M70 engine data: Engine-
mounted heat exchanger 36
3.4 12V 2000 M70 engine data: Separate heat
exchanger 39
3.5 16V 2000 M70 engine data: Engine-
mounted heat exchanger 42
3.6 16V 2000 M70 engine data: Separate heat
exchanger 45
3.7 Firing order 48
3.8 Main engine dimensions 49
4 Operation
4.1 LOP controls (without Blue Line automation
system) 50
4.2 Putting the engine into operation (out-of-
service-period > 3 months) 52
4.3 Putting the engine into operation after
scheduled out-of-service period 53
4.4 Starting the engine from LOP (without Blue
Line automation system) 54
4.5 Engine starting from the BlueLine
automation system (control stand) 55
4.6 Engine emergency stop at BlueLine
automation system (control stand) 56
4.7 Operational checks 57
4.8 Clutch – Engaging from LOP 58
4.9 Clutch – Disengaging from LOP 59
4.10 Waterjet – Flushing from LOP (optional) 60
4.11 Stopping the engine from LOP (without
Blue Line automation system) 61
4.12 Stopping the engine at the BlueLine
automation system (control stand) 62
4.13 Emergency stop from LOP (without Blue
Line automation system) 63
4.14 After stopping the engine 64
4.15 Plant – Cleaning 65
5 Maintenance
5.1 Maintenance task reference table [QL1] 66
6 Troubleshooting
6.1 Troubleshooting 67
6.2 LOP alarms 70
7 Task Description
7.1 Engine 77
7.1.1 Engine – Barring manually 77
7.1.2 Engine cranking on starter 78
7.2 Cylinder Liner 79
7.2.1 Cylinder liner – Endoscopic examination 79
7.2.2 Cylinder liner – Instructions and comments on
endoscopic and visual examination 81
7.3 Crankcase Breather 83
7.3.1 Crankcase breather – Cleaning oil separator
element 83
7.3.2 Crankcase breather – Oil separator
replacement, diaphragm check and
replacement 84
7.4 Valve Drive 86
7.4.1 Valve clearance – Check and adjustment 86
MW15407/14E 2012-02 | Table of Contents | 3
DCL-ID: 0000015775 - 001