Mudd-Ox XL - Page 79

79
Figure-6
Heim Jam Nut
Steering Cables Cont.
2. Remove the heim joint from the z-bar/control lever by turning nut “G” counterclockwise. (Figure-4, 5)
3. Loosen the jam nut “E” that attaches to the heim joint “F” (Figure-4, 6)
4. Remove the heim joint “F” from the steering cable by turning it off.
Figure-5
Heim Joint
5. Remove lock nut “C” from the cable (Figure-4, 7). The cable end should now be free to remove.
6. Complete all steps for the opposing side of the cable.
Part 2: Installation
Installation steps are the opposite of removal. Complete Adjustment after installing the new cable(s). Remember
to check that all jam nuts are tight and the Mudd-Ox is safe to operate.
Note: Although the heim joints look similar, there are (2) different styles as shown in Figure-8. Style “G” mount on
the pumps. Style “H” is machined for additional clearance and mount on the control levers.
Figure-7
Cable Jam Nut
Figure-8
Heim Styles
GG HH