MD-1000I / MD-2000I / MD-3000I Explanation of USB Function
MD Series 49
1. "Outlet turn on, after UPS on" allows you to set the time delay. Set the delay
between the time when the UPS turns on and the time when the output
automatically activates. Select "0" if you want the outlet to activate immedi-
ately when the UPS powers up.
2. "Outlet turn off, after AC failure" permits you to make setting for power fail-
ure events. Select this option to shut the output off automatically within the
predetermined time frame in the event of a power outage, in order to shut
down less critical equipment to allow the more critical equipment more bat-
tery time for back-up, etc.
3. "Outlet turn on after AC recovery." Use this option to set the time when the
output will automatically reactivate after regular power has been restored.
4. "Outlet turn off when UPS overload" Select this option to turn off the outlet
automatically when the battery has a specified remaining capacity, which
you specify here. This permits you to shut down less critical equipment in
order to allow the more critical equipment more battery time for back-up,
etc.
5. "Outlet turn off, when UPS overload": This item allows you to specify that
the outlet automatically switches off (bypass mode) during an overload
event, in order to provide more critical equipment with power as described in
the following: Continuously via bypass, or via return to normal operation, if
the shutdown of less critical equipment has successfully remedied the over-
loaded status.
6. To perform further configurations, you need to click Setting. Consider new
settings successfully completed when the UPS emits two audio signal
tones. After you have completed the configuration, shut the UPS down to
make sure the system saves all the settings in the EEPROM. To activate
the new setting, restart the UPS.
7. Manual Control Switch: Click On or Off to activate or deactivate program-
mable outputs and overwrite all previous settings.
To Next Page
Loading...
