For factory assistance, call
888-436-5442
Fax 888-779-2040
Page 9
Operation, continued
Procedure to Replace a Product Bag
These instructions can be found on the Touch Screen in
the Help Menu under “Replace Product Bag”.
Touchscreen will indicate the bag is empty “Drink
making paused, check product supply”.
Press “Replace product”.
Remove holder from cabinet.
Remove empty product bag from holder and
discard.
Position new product bag in holder. Push bag outlet
to bottom of slot in rear of holder.
1.
2.
3.
4.
5.
Open blue ip lid on product bag - snap off and
remove.
Return holder to cabinet.
Press OK on touchscreen panel.
Press Next on the touchscreen - message displays
“Auto Prime” and then “Auto Prime Complete”.
The screen returns to the drink menu screen where
it left off when the fault occurred and nishes the
drink.
6.
7.
8.
9.
10.
To Next Page
Loading...
General