WTB-16PD TRACK-DRIVE POWER BUGGY • OPERATION MANUAL — REV. #0 (08/31/20) — PAGE 21
BUGGY COMPONENTS CONT'D.
23. Fuel Tank/Cap — Remove this cap to add fuel.
Tank holds approximately 5.0 U.S. gallons (20 liters).
DO NOT overfill. Tighten the cap until you hear ‘clicking.’
24. Dump Control Lever — Move this lever forward to
place the tub in the dump (vertical) position. Move the
lever backward to return the tub to the travel (horizontal)
position.
25. Tub Pivot Lever — Use this lever to pivot the tub. Push
the lever forward to rotate tub to the left. Push the lever
backwards to rotate tub to the right.
26. Operator Platform — When the buggy is in use, the
operator shall ALWAYS stand on this platform while
holding onto the handlebar.
27. Access Panel — Remove this panel to gain access
to the dump valve.
28. Hydraulic Oil Sight Gauge — Indicates the hydraulic
oil level.
29. Hydraulic Tank/Cap — Remove this cap to add
hydraulic oil. Tank holds approximately 5.3 U.S. gallons
(20.4 liters). DO NOT overfill.
30. Hydraulic Oil Filter — Spin-on type filter, 10-micron.
Filters out contaminants and debris.
31. Tandem Hydraulic Pump — Machine uses an axial
displacement piston pump and gear pump.
32. Lifting Hooks — When lifting of the buggy is required,
attach a strap/chain of adequate lifting capacity
(3,000 lb./1,360 kg) to these two lifting points.
33. Battery — Always use gloves and eye protection when
handling the battery.
34. Heat Exchanger — Provides cooling for the hydraulic
fluid. Transfers heat from the fluid..
35. Hydraulic Oil Access Port — There are five of these
ports on the machine. Remove the access cover to
clean out the hydraulic oil reservoir.
36. Tie-Down Hook — When transporting of the buggy is
required, attach a strap to these tie-down points (4).
To order go to Discount-Equipment.com
To Next Page
Loading...
