WTB-16PD TRACK-DRIVE POWER BUGGY • OPERATION MANUAL — REV. #0 (08/31/20) — PAGE 7
SAFETY INFORMATION
DO NOT touch, lean on or reach through the dump
mechanism or permit others to do so. NEVER climb on
the power buggy or dump mechanism.
DO NOT operate the power buggy at excessive speeds.
Reckless operation may cause accidents and severe
injury. Slow down when approaching people, wet areas,
and going up and down grades. It is the responsibility of
the operator to adjust speed, as necessary, depending
on the conditions of the road or path.
ALLOW extra time to stop when operating the power
buggy on wet surfaces or loosely graded materials.
DO NOT dump materials that are large and chunky.
These types of materials may shift causing the power
buggy to tip and throw the operator off the machine. The
power buggy is intended for dumping free-fl owing and
loose materials such as dry soil, slag, and wet concrete.
DO NOT dump materials from bucket while the power
buggy is moving.
For walk-behind operation, the operator platform must be
stowed and locked in the up position. The speed should
also be reduced to 3 mph (4.8 kph) or slower.
NOTICE
ALWAYS ensure power buggy is securely placed on
appropriate blocks or jack stands when performing
maintenance requires elevation of the buggy.
ALWAYS make sure the power buggy’s parking brake is
working properly. NEVER operate the power buggy with
a defective braking system.
Ensure brakes are applied when leaving or when using
on a slope.
When parking on a slope, position the power buggy at
a right angle to a slope. Ensure that the parking brake
is engaged and holds the power buggy safely in place
when parking on a slope.
When filling or dumping DO NOT exceed payload
capacity of power buggy.
ALWAYS be aware of traveling conditions. Reduce load
if necessary.
DO NOT activate dump mechanism (tub) if buggy is
facing a downhill slope.
DO NOT
stand in front of or alongside the buggy when
discharging a load.
ALWAYS
block the power buggy with appropriate blocks
when leaving the power buggy parked on a slope.
To prevent unexpected loss of control, DO NOT
engine on a sloping surface.
Ensure that both travel control levers work freely and
return to their neutral position. DO NOT
unless the travel control linkage is working properly.
NEVER
operate the power buggy with bad or worn
rubber tracks. ALWAYS
replace defective tracks with
new ones.
ALWAYS
make sure the hydraulic dumping mechanism
of the tub is working properly.
Avoid sudden stops, starts and changes in direction.
Operate the controls smoothly. DO NOT
or any other controls.
NEVER
attempt to work the control except from the
operator’s position.
NEVER
drive or tow the power buggy in traffi c or on
public roads.
ALWAYS keep the machine in proper running condition.
Fix damage to machine and replace any broken parts
immediately.
The entire power buggy (tub, step plate, shroud, rubber
track, etc.) should be cleaned after every use. Make sure
there is no buildup of concrete, grease, oil or debris on
the machine.
ALWAYS
store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
ALWAYS place the fuel valve lever in the OFF
when the equipment is not in use.
To order go to Discount-Equipment.com
To Next Page
Loading...
