MT5600ZDX Owner's Manual
44
Command: \B
n
Transmit Break to Remote
Values:
n
=\B1-\B9
Default: \B3
Description: \B3 Break length in 100 ms units (non-error correction
mode).
In non-error correction mode, the modem will transmit a
break signal to the remote modem with a length in
multiples of 100 ms according to parameter specified.
The command works in conjunction with the
\K
com-
mand. In error correction mode, the modem will signal
a break through the active error correction protocol,
giving no indication of the length.
*: When the modem receives a break from the remote modem, break is
passed to the DTE as follows: In non-error correction mode
direct
, the break
length is passed; in non-error correction mode
normal
and in error correction
mode, a 300 ms break is passed.
Command: \K
n
Set Break Control
Values:
n
= 0, 1, 2, 3, 4 or 5
Default: 5
Description: Controls the response of the modem to a break received
from the DTE or the remote modem or the \B command
according to the parameter specified. The response is
different in three separate command states.
*The first state is where the modem receives a break from the DTE when the
modem is operating in data transfer mode:
\K0 Enter on-line command mode, no break sent to the
remote modem.
\K1 Clear data buffers and send break to remote modem.
\K2 Same as \K0.
\K3 Send break to remote modem immediately.
\K4 Same as \K0.
\K5 Send break to remote modem in sequence with trans-
mitted data.
*The second case is where the modem is in the on-line command state
(waiting for AT commands) during data connection and the \B command is
received in order to send a break to the remote modem:
To Next Page
Loading...
