Multitech MultiModem MT5600ZDX - Page 45

Chapter 3 - AT Commands, S-Registers and Result Codes
45
\K0 Clear data buffers and send break to the remote mo-
dem.
\K1 Same as \K0.
\K2 Send break to remote modem immediately.
\K3 Same as \K2.
\K4 Send break to remote modem in sequence with trans-
mitted data.
\K5 Same as \K4.
*The third case is where a break is received from a remote modem during a
non-error corrected connection:
\K0 Clear data buffers and send break to the DTE.
\K1 Same as \K0.
\K2 Send break to DTE immediately.
\K3 Same as \K2.
\K4 Send break to DTE in sequence with transmitted data.
\K5 Same as \K4.
Command: \N
n Error Correction Mode Selection
Values: n = 0–5
Default: 3
Description: \N0 Non-error correction mode with data buffering (same as
&Q6 ).
\N1 Direct mode.
\N2 V.42/MNP reliable mode.
\N3 Same as \N2
\N4 V.42 reliable mode.
\N5 MNP reliable mode.
Command: \V
n Single Line Connect Message
Values:
n = 0 or 1
Default: n/a
Description: \V0 Disables Single Line Connect Message.
\V1 Enables Single Line Connect Message, where the for-
mat is: CONNECT, DTE speed>,Modulation></Proto-
col></Compression></Line speed>.
*Connect messages are contingent on X, W, and S95 command settings.