Multitech MultiModem MT5600ZDX - Page 48

MT5600ZDX Owner's Manual
48
Command: -K n MNP 10 MNP Extended Services
Values:
n = 0, 1, or 2
Default: 0
Description: -K0 Disables V.42 LAPM to MNP 10 conversion.
-K1 Enables V.42 LAPM to MNP 10 conversion.
-K2 LAPM answer mode detection phase.
Command: -Q
n MNP 10 Enable Fallback to V.22 bis/V.22
Values:
n = 0 or 1
Default: n/a
Description: -Q0 n/a
-Q1 n/a
*This command is included only for compatibility and performs no function.
Command: -SEC=n
Enable/Disable MNP10-EC
Values: -SDR=n
Default: n/a
Description: -SEC=0 Disables MNP 10-EC
-SEC=1 Enables MNP 10-EC
* -SEC=1,[<tx level>] where <tx level> is an optional transmit level subpa-
rameter (transmit level range is 0 dBm to -30dBm and is specified by a set S
91 value).
Command: @M
n MNP 10 Initial Cellular Power Level Setting
Values:
n = 0-30
Default: n/a
Description: @M0 n/a
,
,
,
@M30 n/a
*This command is included only for compatibility and performs no function.
Command: :E
n MNP 10 Compromise Equalizer Enable Command
Values:
n = 0 or 1
Default: n/a
Description: :E0 n/a
:E1 n/a
*This command is included only for compatibility and performs no function.