Multitech MultiModem MT5600ZDX - Page 47

Chapter 3 - AT Commands, S-Registers and Result Codes
47
Command: -SDR=n Enable/Disable Distinctive Ring
Values: -SDR=n
Default: 0
Description: -SDR=0 Disables Distinctive Ring. Any Valid ring detected is
reported as RING.
-SDR=1 Enables Distinctive Ring Type 1.
-SDR=2 Enables Distinctive Ring Type 2.
-SDR=3 Enables Distinctive Ring Type 1 and 2.
-SDR=4 Enables Distinctive Ring Type 3.
-SDR=5 Enables Distinctive Ring Type 1 and 3.
-SDR=6 Enables Distinctive Ring Type 2 and 3.
-SDR=7 Enables Distinctive Ring Type 1, 2 and 3.
The ring types supported and the corresponding ring cadence detect defini-
tions are as follows:
Table 3-2. Distinctive Ring Types
Command: )M n Enable MNP 10 Cellular Power Level Adjustment
Values:
n = 0, 1, or 2
Default: n/a
Description: )M0 n/a
)M1 n/a
)M2 n/a
*This command is included only for compatibility and performs no function.
Command: *H
n MNP 10 Link Negotiation Speed
Values:
n = 0, 1, or 2
Default: n/a
Description: *H0 n/a
*H1 n/a
*H2 n/a
*This command is included only for compatibility and performs no function.